by Sandy Masayko
The Assistive Technology Department, working in collaboration with our grant funder Comcast and our community partners Science Leadership Academy, Drexel University, Project Vive and MakerBot, is excited to report that our development of Maker Spaces at Easterseals SE PA is well underway! This project consists of two parts: Education of Easterseals staff and local high school student education to provide the basis for creation of Assistive Technology (AT); and setting up maker spaces at each Easterseals SE PA approved private school. The maker spaces will be supplied with 3D printers, soldering kits, moldable plastics, tools, and more. But before anyone can use this new high tech equipment, they need to learn how to design solutions to meet needs and the basics of use of the tools. To meet this need, the AT Department organized two workshops in the fall.
Workshop 1 was held at Drexel University’s Westphal College of Design in September and focused on 3D printing. After a review of AT by Sandy Masayko and an overview of the multiple use of 3D printers by Laurie McGowan, Laura Slatkoff shared her personal experiences in discovering 3D printing and using it to make a customized keyguard for a student. Marcia Leinweber introduced step by step instructions for Computer Assisted Design. Mary Elizabeth McCulloch of Project Vive presented concepts to consider in the design process. The thirty participants then got to work on their shared computers to design the top of a switch. AT Staff members, assisted by Science Leadership Academy (SLA) students who were familiar with 3D design, coached the participants. During the workshop, the SLA students increased their knowledge of AT, and they also videoed and photographed the workshop. At the end of the workshop, Easterseals staff members had homework to complete over the two months before the next workshop: participants were asked to finish their designs and email them to Marcia for printing on the Makerbot 3D printer.
The next workshop, held at SLA in November, allowed the participants to complete their design by constructing a switch for AT. Switch assembly necessitated soldering and wiring of the switch, activities taught by Mary Elizabeth and Joey McCulloch from Project Vive. The participants also learned what tools were in the Maker Spaces and how to use them. Laurie McGowan led participants in creating battery interrupters that can be used to enable toys and devices to be activated with a switch. Sandy introduced how to use a moldable plastic that can be used to create adaptations. As with the first workshop, the SLA students proved to be great coaches to ES staff members as they learned to wire and solder.
Response by the staff to the workshop was overwhelmingly positive. In our pre and post testing for each workshop, the staff members indicated that they significantly increased their knowledge of AT, 3 D printing and tools for creating solutions for people with disabilities. The next phase of the project will be establishment of the Maker Spaces at each approved private school sites. We can’t wait to see what our staff will create!